© 2006 GE ECM by Regal-Beloit
- 69 -
Indoor Blower Motors
v0.2
Be certain to form a drip-loop so that water cannot enter the motor by draining down
the cables. Condensate or droplets can accumulate in the harness and may find
their way into the motor.
Re-install the blower/motor assembly
into the HVAC system by following
the manufactures’ guidelines.
Plug the 16-pin connector and the 5-pin
connector back into the motor. Make
sure the keyed connectors are inserted
properly ad securely until they click.
To Next Page
Loading...
