Engine & Controls
1-61
• Wear your safety lanyard at all times.
• Never shi the controls with the engine not running. Control,
linkage, and/or stern drive damage may occur.
• For more information, read your engine manufacturer’s manual
before operating the remote control.
Safety Lanyard (Interrupter Switch)
e safety lanyard (used on selected control levers), sometimes
called an interrupter switch is attached to the operator and the
remote control panel. Should the operator lose control of the vessel
and become dislodged from his/her seat or fall overboard, the
lanyard will shut the engine o .
Make sure the lanyard is installed to the driver’s belt before operating
the vessel. Flip the switch to the run position before starting the
engine.
INTERRUPTER SWITCH MUST BE ATTACHED TO THE OPERATOR
WHILE THE ENGINE IS RUNNING. A QUALIFIED OPERATOR MUST
BE IN CONTROL AT ALL TIMES. READ THE OWNER’S MANUAL
BEFORE USE.
ATTACH TO
OPERATOR
To Next Page
Loading...
