6-6
Anchor Windlass
If installed the
windlass features a
stainless steel
anchor complete
with swivel in the
anchor locker. A 50
amp breaker for
windlass
overcurrent
protection is
located at the
battery management panel. A rocker switch located
at the anchor locker controls power to the windlass.
Located below the windlass switch in the anchor
rope locker is a cut-off switch similar looking to a
battery switch. It is used to disconnect the windlass
circuit. If the deck cut-off switch is not energized
the windlass switch will not activate the windlass.
Never use the windlass to break the anchor free from the bottom.
This may cause excessive strain on the windlass motor and or
hardware.
https://www.boat-manuals.com/
To Next Page
Loading...
