Engine & Controls
CHAPTER 3
3-5
water to exit through the exhaust manifold. For more information read
your outboard engine manual or contact your Regal dealer. Dealers
have the necessary knowledge and tools to troubleshoot any engine
related problems.
WARNING
!
Allow the engine to cool to ambient temperature before
inspecting, servicing or repairing the engine. Some engine
components and fluids are extremely hot even after the engine
has been shut down. Allow sufficient time for all engine
components and fluids to cool to ambient temperature before
attempting any service procedure. Failure to do so could result
in death or serious injury.
Never operate the engine without a functioning thermostat. The
engine may overheat and cause damage.
Freshwater Flushing Attachment
Your outboard features a fresh water ushing system. After linking up
to a fresh water hose at the ush port, water can be pumped through
the engine’s raw water cooling system to ush out all salt and debris
that may be left behind. Normally there is a hose thread tting on
the side of the engine. After the connection is opened a garden hose
is connected to the tting and the engine can be ushed. It is best to
connect the ushing system up when the engine is warm since the
thermostat is open at this time to allow water to circulate through the
entire head rather than bypassing the cylinder head areas. Do not run the
engine while using the ushing system device as engine damage may occur.
https://www.boat-manuals.com/
To Next Page
Loading...
