Regal CB500REG - User Manual

Questions and Answers

Y
yoneillAug 2, 2025
How to fix Regal CB500REG Indoor Furnishing remote that illuminates but doesn't work?
- C
  Cody FrancisAug 3, 2025
  If your Regal Indoor Furnishing remote control lights up but doesn't activate the base, try these steps: First, unplug the power cord, wait 30 seconds, and plug it back in to reset the electronics. Next, check the outlet by plugging in another working appliance to rule out a defective surge protector or outlet. Also, verify that the electrical circuit breaker hasn't tripped. Finally, you may need to re-link the remote control.
J
Justin DouglasAug 8, 2025
Why won't my Regal CB500REG Indoor Furnishing remote control illuminate?
- B
  Brittany BarajasAug 8, 2025
  If the remote control for your Regal Indoor Furnishing does not illuminate, the first thing you should do is replace the batteries.
B
Brandon GrantAug 14, 2025
What to do if my Regal CB500REG Indoor Furnishing head or foot won't return to flat position?
- P
  Patricia WarrenAug 15, 2025
  If the head or foot section of your Regal Indoor Furnishing elevates but doesn't return to the flat position, there might be an obstruction in the base mechanism. Elevate the base and check for, and remove, any obstructions. Also, the headboard may be too close to the mattress. Ensure there's enough space between the headboard brackets and the mattress, and adjust if necessary.
K
Kurt LewisAug 20, 2025
How to reduce massage motor noise in my Regal Indoor Furnishing?
- K
  Kayla OrtizAug 20, 2025
  If your Regal Indoor Furnishing massage motor is making excessive noise, consider these solutions: If the base is on a hard floor, place carpet pieces or rubber cups under each leg. Ensure the base isn't against a wall or other object that could cause vibration. If installed in a wood bed frame, check if the vibe motor is causing the frame to vibrate. Also, make sure the headboard attachment hardware is tightened firmly.
M
Marcus GrayAug 27, 2025
Why is there interference with the head or foot lift function on my Regal CB500REG Indoor Furnishing?
- S
  Sara LynchAug 27, 2025
  If you experience minor interference with the head or foot lift function of your Regal Indoor Furnishing, try the following: Check and replace the remote batteries if needed. Ensure you're following the motor's duty cycle (no more than one minute of operation over an eight-minute period). Press the lift buttons squarely and accurately. The control box may be experiencing common Radio Frequency Interference from other radio transmitting devices.