22
D. If the motor fails either of these tests or does
not spin freely when rotated by hand,
replace
the motor and control module following the
guidelines on page 24.
Insert the 3-pin connector back into the new
control module. A slight click will be heard when
inserted properly. This connector is keyed for
proper connection.
Attach the new control module with the plug
connections oriented down (see figure 7,
page 23), insert the appropriate bolts and tighten.
Due to model replacements, some motors may
need to be rotated in their mount to orient the plug
connectors properly.
See below for model specific notes and/or follow
any OEM instructions included with the new
control.
Model 2.0 & 2.3 - These models are no longer
available and can only be replaced with an OEM
Eon
®
kit that includes a motor adapter ring (see
below).
Model Eon - This model can only be replaced
with with an OEM Eon motor.
Model 2.5 - This model is no longer in
production. It can only be replaced with an OEM
3.0 kit that includes a 16-4 pin wiring adapter and a
motor adapter ring.
5.
6.
16-4 Pin
Adapter
Completed
Assembly
Adapter
Ring
Eon
Control
Model 2.0 or
2.3 Motor
To Next Page