Regency 400 Series - Wall Mounting the Telephone

User’s Guide
Wall Mounting the Telephone
26
Regency™ Series 400 Single Line Caller ID Telephone
User’s Guide
Using the Features and Options
Regency™ Series 400 Single Line Caller ID Telephone
9
Wall Mounting the Telephone
1 First, remove the clip provided in the set
by sliding it straight up (Figure 1) , and
replace with the Wall Mount Clip found in
the packaging, as shown (Figures 2-3).
2 Replace the desk mount wedge with the
wall mount wedge. To remove the desk
mount wedge, press the two release tabs
as shown. The wedge will snap off. Insert
the tabs of the wall mount wedge (Figure
4) and snap into place.
3 Insert the short line cord into the jack at the rear of the
telephone. Plug the opposite end into the jack on wall.
Turning Message Waiting Light On/Off Manually
This allows the first user of voicemail the opportunity to notify
another user that a voicemail message is waiting for their review.
It also allows the user to stop the message waiting light from
flashing if it is doing so in error. When used, it will reset the light
signal in the phone. This does not send any outgoing signal to an
outside voicemail service.
When the message waiting light is turned off, it will re-activate
when a new phone message arrives in voicemail.
To turn ON:
While in on-hook state, and the light
is OFF, press the * key for three
seconds and the TouchLite® will
light.
To turn OFF:
While in on-hook state, and the light
is ON, press the * key for three
seconds and the TouchLite® will
turn off.
Note: When turning light off, the Mail Icon on the LCD display will
also turn off.
Figure 1
Figure 3Figure 2
Wall Mount Clip
Figure 4