15
Installer's Information
A 120V 12.5A 60Hz supply is required.
Rated power consumption:
Ei29: 1400 Watts
Optional (Hardwire only) 240V 2 phase 15A 60Hz supply can be utilized.
Rated power consumption:
Ei29: 2800 Watts
THIS APPLIANCE MUST BE GROUNDED.
IMPORTANT: A 15 AMP, 60Hz circuit is required for 120 VAC installation. Additional appliances on the same circuit may exceed the
current rating of that circuit. A dedicated circuit is not required, but is preferred to prevent circuit breaker trips or fuse failure. Optional
240 VAC 2 phase may only be hardwired. FAILURE TO ADEQUITLY POWER APPLIANCE AT REQUIRED VOLTAGE AND AMPERAGE WILL
VOID YOUR WARRANTY.
A 3 prong plug with 93.3" (2.37m) power lead and a separate hard wiring kit are supplied.
2 x Remote control handset battery (AAA).
Note: The wiring from the appliance to the breaker must be supplied by a qualified electrician. This is not supplied with the appliance.
MAIN CONTROL BOARD
REMOTE RECEIVER
BOARD
REMOTE CONTROL
Hardware RC01-070A01 RF290B V1.2 RF290A-TX-V1.3
Software V0 V2.4.1
Frequency ASK/OOK 433.92MHZ
Maximum Transmit Power 10mW
CONTROL SYSTEM TECHNICAL DATA
ELECTRICITY SUPPLY
To Next Page
Loading...
