To Next PageTo Next Page
Need help?Do you have a question about the Regency I2100M and is the answer not in the manual?
Safety labels and their details for 11100S and 12100M models.
Safety labels and their details for 13100L and H2100M models.
General preparation and checks before installing the insert.
Requirements for chimney systems and fireplace specs for installation.
Required clearances to combustible materials for installation.
Leg option, masonry/factory built installation, flue connector bracket.
Steps for installing faceplates and trim for different models.
Instructions for installing the fan and blower assembly.
Installing firebricks, baffles, and secondary air tubes.
Operating the draft control and installing the door handle.
Steps for starting the initial fire and warming up the unit.
How to operate the fan/blower system for optimal performance.
Safe procedures for removing and disposing of ashes.
Important safety precautions for using the fireplace insert.
Information on creosote formation, removal, and prevention.
Maintaining gold-plated doors, gaskets, latches, and glass.
Detailed list of parts for I1100, I2100, and I3100 models.
List of parts specific to the H2100 Hearth Heater model.
List and diagrams of various firebrick parts.
Coverage, conditions, and exclusions of the warranty.
General| Efficiency | 70% |
|---|---|
| Vent Type | Direct Vent |
| Weight | 150 lbs |
| Ignition System | Electronic Ignition |
| Venting | Direct Vent |
| Fuel Type | Natural Gas or Propane |
| Heating Capacity | Up to 1, 500 sq. ft. |
| Heating Area | Up to 1, 500 sq. ft. |
| BTU Output | 26, 000 BTU/h |
| Coverage Area | Up to 1, 500 sq. ft. |
