66
Owner's Information
OPERATING THE APPLIANCE
- ADVANCED OPERATION
Timer in Normal Mode
Flame
Power
Heating/ Advance
Mode
Temperature Sensor
Convection
Display
Fuel Bed
Mood Lighting
Strip (Optional)
Heating Period
Battery Power
Actual Room
Temperature
Timer Mode
Advance
Temperature
Setting
Time and Day
Comfort
Setting
TURN ON/OFF
Press button to turn on the flame effect.
Press
button to turn off all the functions under the normal
heating control mode.
Press
button to turn off the flame effect under daily and week
timer heating mode.
WEEK DAYS/ TIME/ COMFORT TEMPERATURE
AND UNIT SETTING
Ensure the clock is set to the correct time.
Press
for 3 seconds.
Press the ‘’ or ‘’ button to choose setting.
The selected character will be highlighted.
Press the ‘+’ or ‘-’ button to adjust the number.
Time: 24-hour system.
Select Comfort temperature from 15-25℃.
Temperature unit: ℃/℉.
Press the
button for 3 seconds or wait 10 seconds to save and
exit the week, time and heating temperature setting.
DAILY TIMER HEATING
The following heating periods have been preset, but can be altered
if desired:
06:00 until 08:00
17:00 until 22:00
Press
until shows at the upper right corner of the screen.
Hold the button for 6 seconds.
3 timed heating periods can be set per day.
Press ‘’ or ‘’ to choose hour or minute.
Press ‘+’ or ‘-’ to set the number.
The minute increment / decrement by 15min per press.
Hold the button for 3 seconds or wait for 10 seconds to save
and exit the heating time period setting.
Press
to check the daily timer mode.
To turn heating off, return to Normal Control Mode.
When in Daily Timer Mode switching the appliance off with
the remote will stop the light output. The heat output will
continue according to the timer settings.
ADJUSTING THE SET TEMPERATURE
Press the ‘+’ or ‘-’ button to increase or decrease the temperature
on the basis of COMF temperature.
COMF means the actual temperature is the same as setting.
ECO means the actual temperature is 2℃ lower than the setting
temperature.
ECO- means 4℃ lower.
COMF+ means 2℃ higher.
COMF++ means 4℃ higher.
ADAPTIVE START CONTROL
The heater will automatically determine the appropriate time to
heat to ensure that it will reach the set-pointed temperature at the
set time (up to 45 minutes prior to the set time).
To Next Page
Loading...
