INSTALLING THE TRANSMITTER HOLDER
1. Remove the cover from the holder.
2. Attach the holder with the two screws provided.
3. Replace the cover into holder.
Fig. 14
Cover
Holder
Screws
CARE AND CLEANING
Periodically it may be necessary to re-tighten blade to blade arm screws or blade arm to motor screws to prevent
clicking or humming sound during operation. This is especially true in climates with broad temperature and
humidity ranges.
When dusting the blades, you must support the blade to prevent bending - no pressure should be applied to the
blades. If you experience any flaws in the operation of your fan, please check the following points.
11
To Next Page
Loading...
