RAUTOOL A-LIGHT2
UsInG THe TOOL
1. When changing the compression
jaws, always rst push the long
compression jaw and then the short
one onto the tool cylinder.
3. By rotating the tool cylinder, the
compression jaw can be brought into
the correct working position.
2. Fix the compression jaws with
the pins.
Attention:
Ensure the identical alignment of the
double jaws (for example, size 25)!
Always push the pins in all the way!
4. To insert the battery, push it com-
pletely into the holder until it locks
into position on its own.
In the manufacture of vertical pipes,
the compression sleeve can be held
by means of the pipe gripper. The
pipe gripper also serves to push back
or hold the insulation or corrugated
tube so as to provide the space
needed for making the compression
sleeve joints.
To Next Page
Loading...
