RAUTOOL A-LIGHT2
mAInTenAnce nOTes
Regular inspection: Repairs
Risk of injury!
Always remove the battery or unplug from the mains before cleaning
and inspection.
- Always keep jaw sets, expanding tools and cylinders clean.
When soiled, clean them with a brush and oil them. Then store the
tool in a dry place.
- Before every use, check the jaw sets, expanding tools and the
A-light2 basic tool for damage or visible wear. Damaged tools must
not be used anymore and should immediately be sent to an authori-
sed service center for repair.
- Make sure that the jaw sets are fully applied across the whole
surface and at a right angle during the compression process, and
the compression sleeve is inserted up to the fitting collar.
- Regularly grease the expanding tool tapers. Do not apply grease
to the surface of expander segments! Should excess grease reach
the expander segments, the segments must be thoroughly cleaned
(e.g. cleaning solvent) and then dried.
Risk of accident!
Do not perform any repairs on the tool yourself! Repairs should only be
carried out by an authorised service center.
Storage:
Never store the tool if wet! Dry the tool and grease it. Then store it in
a dry place.
As a matter of principle, store the tool in its final position (extended
cylinder or jaw sets) to extend its service life.
To Next Page
Loading...
