Rehau RAUTOOL A-LIGHT2 - ASSEMBLY PROCEDURE

27
EN
RAUTOOL A-LIGHT2
AssemBLY pROcedURe
1. Using pipe cutters, cut pipe to required length at right angles and without
leaving burrs.
Attention:
Keep your hand at a safe distance from the tool. Do not use saws, or similar!
2. Slide compression sleeve onto pipe.
Attention:
With metal compression sleeves, the inside taper must point towards the joint.
3a. Expansion using expanders:
Expand pipe, rotate 30°, and repeat.
The min. distance between expander head and compression sleeve must be
two compression sleeve lengths.
3b. Expansion using expander set:
Expand pipe, rotate 30°, and repeat.
The min. distance between expander head and compression sleeve must be
two compression sleeve lengths.
3c. Expansion using expander bit
Expand pipe, rotate 30°, and repeat.
The min. distance between expander head and compression sleeve must be
two compression sleeve lengths.
Failure to observe these instructions may result in damage to the jointing system, to the tool and in personal
injury.
Do not tilt the pipe when expanding! Do not expand under bending
stress!
Do not tilt the pipe when expanding! Do not expand under bending
stress!
Do not tilt the pipe when expanding! Do not expand under bending
stress!