RAUTOOL A-LIGHT2
TOOL pRepARATIOn
Caution! Risk of injury.
Improper handling of the REHAU tool may result in personal injury and/
or material damage.
- Make sure that whenever the jaw sets are changed the pins are complete-
ly and safely locked in place.
- Before changing the jaw sets, the battery must denitely be removed from
the tool (inadvertent actuation).
- Before each use, check the jaw sets, expander bits, expander sets and the
tool for damage or visible wear. Damaged tools must no longer be used
and should immediately be sent to an authorised service center for repair.
- When inserting the expander bit, click it completely into the compression
jaws.
- The entire surface of the receiving groove of the bit must lie in the com-
pression jaws.
Before actuating the tool, check to make sure that the seating and
clamping action of the bit in the jaws are correct (to avoid falling out). If
necessary, increase the clamping action through short actuation of the
tool‘s operating switch.
Expander:
When screwing on expander heads
open expander completely (> 90°
position). Always screw expander
heads fully on. Use expander heads
that conform to the pipe dimensions
(for example, 16 x 2.2).
Expander set:
When using the expander set, push
the jaws (rst long and then short) on
rst and then insert the expander set
into the cylinder.
Turn the expander set until the pin
slips into the groove. Then x the
jaws and expander set using the
pins.
Attention:
Fully insert the pins.
Expander bit:
Attention! When inserting the
expander bit for hydraulic expanding,
fully click the correspondingly sized
expander bit into the respective
compression jaws and check for t
(clamping).
Attention:
As a matter of principle, always
insert the expanding tool into the
pipe up to the stop.
Expanding tool
To Next Page
Loading...
