REITEL STEAMY MINI - Troubleshooting

12
Troubleshooting
Device doesn’t work after turning it on.
a. Check the building’s fuse
b. Check the device’s fuse.
Safety valve (10) opens or water drips.
a. Slightly down-regulate heating control (5)
and call service. Note: If applicable,
don’t remove cover and don’t close
opening.
b. Tank is overfilled → drain some water
off.
Control lamp (3) shines, although water has
been filled up and steam was taken out.
Temperature limiter (11) or heating control
(5) switched off by itself → Set heating
control to max. and press temperature limiter
at the back of he device again after cooling
down.
Tank cap (6) untight.
→ Replace cap or seal.
No steam.
Device might be calcified, valve might be
blocked, buttons or valves defective → call
customer service.
No steam pressure.
Heating control (5) is not set to max.
Pistol drips.
Device might be calcified, valve might be
blocked → decalcify.
Static charge.
Touch contact screw (15) at the steam
gun while jetting
(see chapter 2.2 Specific Safety Notes).
High wear of seals.
→ Ventilate tank by activating steam gun
button (13).
Machine doesn’t work after turning it on,
power switch (2) doesn’t shine.
No power at the socket → Check the
building’s fuse.
Machine’s fuse has blown.
→ Unplug the whole unit and change the
device’s fuse (12).
Short circuit
In case of water in the housing shut down
device and pull the plug. Contact customer
service.
Attention: Water temperature range up to
150 degrees C – Danger of scalding!