Rekluse Core EXP - Hydraulic Page 9
20. Optional: If you purchased the Rekluse Slave
Guard accessory, install it now using the
instructions in the kit.
21. Remove the cap and bladder from the clutch
master cylinder and top off the clutch fluid.
22. Attach the supplied bleed tube to the banjo bolt
port and loop it into a suitable catch bottle.
23. Pump the clutch lever 3-5 times then hold it
against the bar/grip.
24. Using an 8mm wrench, open the bleed port. Air
and fluid should come out of the bleed tube.
Tighten the bleed port.
25. Slowly release the clutch lever and check the
fluid level in the clutch master cylinder.
To Next Page
Loading...
