GET READY FOR TAKE OFF.
Thank you for purchasing the Terminal Mix
8 Reloop‘s new agship performance
controller developed for Serato DJ.
Here are the steps to get started:
1) Visit the link below to get your FREE
copy of Serato DJ
serato.com/dj/license/code
Note:
If you are a PC user, please visit the
Terminal Mix 8 product site on
www.reloop.com and head to the download
section to download and install the PC
ASIO driver. Mac users do not require a
special driver.
2) Now connect the Terminal Mix 8 to your
computer via USB; also connect the
included power supply and run either the
RCA (unbalanced) cables or XLR (balanced)
cables to your speakers or amplier. Don‘t
forget to connect your headphones to one
of the two jack inputs on the front panel.
3) Power on your unit, start the Serato DJ
software and start mixing.
Note:
Make sure, when turning on the power, to
have your master and headphones volume
low and slowly increase.
MAXIMUM CONTROL
SPEAKERS
XLR / RCA
POWER SUPPLY
HEADPHONES
USB CABLE
To Next Page
Need help?
General
