APPLICATION IN ACCORDANCE WITH REGULATIONS
1. This device is a professional DJ MIDI controller with integrated 4-channel soundcard that can control software. The device should be connected via USB cable to a computer or via iOS
Connection cable to the iPad / iPhone.
2. This product is authorized for connection to 100 - 240 V, 60/50 Hz AC via mains adapter (included) and is designed exclusively for indoor application.
3. If the device is used for any other purposes than those described in the operation manual, damage can be caused to the product, leading to exclusion of warranty rights. Moreover, any
other application that does not comply with the specied purpose harbours risks such as short circuit, re, electrical shock, etc.
4. The serial number determined by the manufacturer must never be removed to uphold the warranty rights.
MAINTENANCE
5. Check the technical safety of the device regularly for damage to the mains cord or the casing, as well as for wearout of wear parts such as rotary knobs and sliding faders.
6. If it is to be assumed that a safe operation is no longer feasible, then the device must be disconnected and secured against accidental use. Always disconnect the mains plug from the outlet!
7. It must be assumed that a safe operation is no longer feasible, if the device bears visible defects, if the device no longer functions, following longer storage under unfavourable conditions
or after major transport stress.
SCOPE OF DELIVERY
- TOUCH controller
- Power supply unit
- USB cable
- Instruction manual
- License card
SETUP AND CONNECTIONS
1. Connect your output devices (headphones, speakers, etc.) to the TOUCH. Audio output takes place via the master output (JACK and RCA).
2. Connect your microphone to the TOUCH. The microphone input takes place directly on the master channel.
3. Make sure that the Mixon is turned off and that the master faders is in the 'min' position.
4. Connect all devices to a power outlet and turn them all on.
INSTALLATION
1. Go to http://www.reloop.com/touch and download the "Reloop TOUCH Installer & Driver Package“.
2. Open the installer le via double-click.
3. During installation you will be asked to enter a licence code. You can nd this code on the licence card which is included in the TOUCH gift box.
4. Follow the instructions in order to complete installation.
5. Go to http://www.virtualdj.com/reloop and follow the instructions in order to download and activate VirtualDJ Pro for your TOUCH controller.
6. You will be asked to enter another licence code. This can be found on the back of your licence card.
7. Now turn on the device and start VirtualDJ.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
