Reloop MIXON 4 User Manual

RELOOP MIXON 4
FIRMWARE UTILITY SETTINGS
This document describes all available rmware settings for MIXON 4 which
can be set on the device itself.
MODES & SETTINGS:
1. LED Check Mode
2. Firmware Version Check
3. En-/Disable LED Stand-by Sequence
4. Activate Vegas mode (LED Demo Mode)
5. Firmware Update Mode
6. Adjust LED back lit intensity
7. Adjust crossfader CUT-IN
Before launching any rmware mode, please disconnect the USB or iOS
cable, otherwise the set state may not be displayed properly.
Each rmware setting mode can be entered by holding a dedicated button
while powering on the unit. To save and exit a mode, power off the unit.
Revision v2 (11/16)
PLEASE REGULARLY CHECK FOR
UPDATES ON WWW.RELOOP.COM

Reloop MIXON 4 Specifications

General

Product color	Black
Scratcher type	Digital Vinyl System (DVS) scratcher
Platter backlight	Yes
Number of drum pads	8
Built-in optical drive	-
Number of mixer channels	4 channels
Number of scratcher platters	2
USB ports quantity	1
Headphone connectivity	3.5 mm/6.35 mm
Microphone connectivity	6.3 mm
Current	3 A
Input voltage	12 V
Power supply type	DC
Minimum RAM	4 GB
Minimum processor	32 bit/64 bit: i3 / i5 / i7
Minimum processor speed	1.07 GHz
Minimum storage drive space	5000 MB
Mac operating systems supported	Mac OS X 10.10 Yosemite, Mac OS X 10.11 El Capitan, Mac OS X 10.12 Sierra, Mac OS X 10.9 Mavericks
Windows operating systems supported	Windows 10, Windows 7, Windows 8.1
Minimum display resolution requirement	1280 x 720 pixels
Built-in display	No
Cables included	AC, Lightning, USB

Weight and Dimensions

Depth	376 mm
Width	657 mm
Height	45 mm
Weight	5300 g

Summary

Reloop Mixton 4 Firmware Utility Settings

LED Check Mode

Activates a mode to illuminate all LEDs for testing responsiveness. Press PLAY while powering on.

Firmware Version Check

Checks the currently installed firmware version. Press CUE while powering on.

LED Standby Sequence Control

Enables or disables the automatic LED standby sequence. Press SYNC while powering on.

Activate Vegas Mode

Activates a demo mode with a Vegas-style LED sequence for presentations. Press SHIFT while powering on.

Firmware Update Mode

Enters the device into a mode for firmware updates. Press BACK while powering on.

Adjust LED Backlit Intensity

Adjusts the brightness of all button LEDs. Press BROWSE encoder while powering on.

Adjust Crossfader Cut-In

Adjusts the crossfader cut-in lag in 0.1mm increments. Press (FX-)TAP while powering on.