REMET CNC TECHNOLOGY SP. Z O.O.
Page 18 of 51
Manufacturer of machinery and equipment, machining
Rules of conduct in emergency situations posing hazards to the life or
health of employees
1. After finding defects, damage or malfunction of the machine or its
components, the wood chipper shall be immediately turned off and immobilized
and the superior should be notified. Resumption of work without removing the
damage or cause of the failure is unacceptable.
2. If you need to leave the chipper during unattended operation, turn off the
combustion engine and ignition, and immobilize the machine.
3. In the event of any doubts as to the observance of safety conditions at work,
the employee has the right to stop work and contact his supervisor to clarify the
situation and make a decision.
4. In the event of an accident at work, disconnect the power supply (in the RE-
120 model switch off the PTO drive and tractor immediately when working with
the tractor) and report the accident to your supervisor, call an ambulance if
necessary. Leave the workplace in the condition in which the accident happened.
5. If there is any doubt as to how the work should be done, work should be
stopped and guidance should be sought from the supervisor.
6. In the event of a fire in the internal combustion engine or in the tractor driving
the wood chipper, if there is a safe option, immediately turn off the machine and
follow the fire fighting instructions.
7. A faulty or damaged or remaining in service chipper should be withdrawn from
use, and clearly marked with information boards and secured in a way that
prevents its starting.
5. PROHIBITED ACTIONS
1. It is forbidden work with a chipper after drinking alcohol or intoxicants
and psychotropic substances (drugs) and drugs that reduce the ability to react.
2. It is forbidden use of the chipper by:
• Children (below the minimum age of the operator defined by local
regulations),
• Pregnant women,
• People with limited mental abilities.
3. It is forbidden starting work with a chipper without checking the
technical condition of the device.
To Next Page
