RENA Address Printer
612s(Ei1)_Operations Rev: 5/12/03 47
Error message Description Solving the problem
WRONG LCA REVISION!
PLEASE UPDATE LCA!
Incorrect LCA revision loaded Obtain valid flashware from Support/
Internet and load into the printer
Reduce Paper Speed:
START to continue!
Paper speed is set too fast for print
quality and type of data being sent.
Set “Auto Paper Speed“ to on, or
80% or 60%. Try all three.
Feed Motor Jammed!
START to continue!
The paper motor is blocked Set paper separator.
Replace control board
Feed Motor Controller
Fault! Call Service!
Fault in motor control system Replace control board
9.3.2 Warnings
Warning Description Solving the problem
Warning:Non-Existant
Font Selected
Font not in printer Examine print image, unlock font
setting in the printer
Position Warning!
Reduce Left Margin!
Print area outside print area Check print area outside paper
lenght, reduce left margin on PC, set
OFFSET EDGE to 0
Macro Too Large Or
Wrong Hor. Position!
Graphics too wide Graphic should alsways be on top
left, max. 101mm wide, then convert
to macro
Macro ID# In Use
Macro Load Ignored!
Macro (same number) already
exists, overwriting not possible
Delete macro and redefine it
MACRO HEIGHT
EXCEEDS 1.5 INCH
Macro is too high Reduce the height of the graphics by
38.1 mm
Image Height Exceeds
The Maximum Value!
Print area higher than 38.1mm
To Next Page
