WARNING
•
In an accident you could be thrown from the
vehicle through an open sunroof. Adults
should always use seat belts and children
should always use seat belts or child restraint
systems.
•
Never allow anyone to stand up or extend any
portion of their body out of the opening while
the vehicle is in motion or while the sunroof is
closing.
CAUTION
•
Remove water drops, snow, ice or sand from
the sunroof before opening.
•
Do not place any heavy objects on the sunroof
or surrounding area.
AUTOMATIC SUNROOF
➀
CLOSE/TILT UP
➁
OPEN/TILT DOWN
The sunroof operates when the ignition switch is in
the ON position.
Sunshade
To open or close the sunshade, slide the sunshade
manually.
The sunshade will open automatically when the sun-
roof is opened. The sunshade needs to be closed
manually by sliding it.
Sunroof
Sliding:
To fully open or close the sunroof, push the switch
to the OPEN
➁
or CLOSE
➀
position and release
it; it need not be held. The roof will automatically
open or close all the way. To stop the roof, push the
switch once more while it is opening or closing.
Tilting:
To tilt up, first close the sunroof, then push the
switch to the TILT UP position
➀
and release it; it
need not be held. To tilt the sunroof down to the
closed position, push the switch to the TILT DOWN
position
➁
.
Auto-reverse function
WARNING
There is asmall distance just before the closed
position which cannot be detected. Make sure
that all passengers have their hands, etc. inside
the vehicle before closing the sunroof.
The auto-reverse function enables the sunroof to
automatically reverse when something is caught in
the sunroof as it is closing. When the control unit
detects an obstacle, the sunroof will open immedi-
ately.
If the sunroof cannot be closed automatically when
the auto reverse function activates due to amalfunc-
tion, push and hold the sunroof switch to the CLOSE
➀
position.
Depending on the environment or driving conditions,
the auto-reverse function may activate if an impact
or load similar to something being caught in the
sunroof occurs.
If sunroof does not operate
If the sunroof does not operate properly, perform
the following procedure to initialise the sunroof op-
eration system.
1. If the sunroof is open, close it fully by repeatedly
pushing the sunroof switch to the close position
➀
to tilt the sunroof up.
2. Push and hold the switch to the close position
➀
.
3. Release the sunroof switch after the sunroof
moves slightly up and down.
4. Push and hold the switch to the open position
➁
to fully tilt the sunroof down.
5. Check if the sunroof switch operates normally.
NIC2733
SUNROOF (where fitted)
2-42 Instruments and controls
To Next Page
Loading...
