Heated seats (where fitted)
The front seats can be warmed by built-in heaters.
The switches located on the centre console can be
operated independently of each other.
1. Start the engine.
2. Select heat range.
•
For high heat, push the <HI> (High) side of
the switch
➀
.
•
For low heat, push the <LO> (Low) side of
the switch
➁
.
•
The indicator light
➂
will illuminate when the
heater is on.
3. To turn off the heater, return the switch to the
level position. Make sure the indicator light turns
off.
The heater is controlled by athermostat, auto-
matically turning the heater on and off. The indi-
cator light will remain on as long as the switch is
on.
When the vehicle’s interior is warmed be sure to
turn off the switch.
CAUTION
•
The battery could run down if the seat heater
is operated while the engine is not running.
•
Do not use the seat heater for extended peri-
ods or when no one is using the seat.
•
Do not put anything on the seat which insu-
lates heat, such as ablanket, cushion, seat
cover, etc. Otherwise, the seat may become
overheated.
•
Do not place anything hard or heavy on the
seat or pierce it with apin or similar object.
This may result in damage to the seat heater.
•
Any liquid spilled on the heated seat should
be removed immediately with adry cloth.
•
When cleaning the seat, never use petrol, thin-
ner, or any similar materials.
•
If any malfunctions are found or the heated
seat does not operate, turn the switch off and
have the system checked by an approved
dealer or qualified workshop.
REAR SEATS (Double Cab model)
Folding
The jack and tools are stored in the tool storage
compartment located under the rear seat cushion.
To access the tool storage compartment, fold the
rear seats in the following steps.
1. Remove the hook
ja.
2. Lift up the seat cushion
➀
.
3. Secure the seat cushion with the strap
➁
.
To remove the jack and tools, see “Preparing tools”
in the “6. In case of emergency” section.
Do not drive the vehicle with the rear seat folded.
When returning the rear seat to the original position,
be certain the seat belts and the buckles are posi-
tioned properly. Secure the seat cushion using the
hook
ja.
JVR0322XZ
NIC2816
Safety —seats, seat belts and supplemental restraint system 1-5
To Next Page
Loading...
