Child restraint installation using the vehicle’s seat belt
The following restriction is applied when using child restraints varying by infants weight and installation position.
Mass group
Seating position
Front passenger seat
(Air bag ON)
Front passenger seat
(Air bag OFF)
Second row outer seat Second row centre seat *4
0<10 kg XL*3 U/L*2 U*2
0+ <13 kg XL*3 U/L*2 U*2
I9-18kgX L*1,*3 U/L*1,*2 U*1,*2
II 15 -25kgX L*1,*3 U/L*1,*2 U*1,*2
III 22 -36kgX L*1,*3 U/L*1,*2 U*1,*2
U: Suitable for “Universal” category child restraint systems, forward and rearward facing, approved for use in this mass group.
UF: Suitable for “Universal” category child restraint systems, forward facing only, approved for use in this mass group.
L: Suitable for particular child restraint systems of the “Specific for the vehicle”, “Restricted”, or “Semi-universal” categories, approved for use in this mass group.
X: Seat position not suitable for children in this mass group.
*1: Move the head restraint to the uppermost position or, if necessary, remove it in case of any interference with the child restraint. Do not remove head restraint when using abooster
cushion only.
*2: Adjust the front seat(s) slide position sufficiently forward and/or the seat height adjustment (if available) to the uppermost position to ensure there is no contact between child seat
and back of front seat.
*3: Move the front passenger seat as far rearward as possible.
*4: Suitable only for “Universal” category of child restraints. Do not install child restraints with support leg.
Safety —seats, seat belts and supplemental restraint system 1-17
To Next Page
