EasyManua.ls Logo

Renault CAPTUR 2024 - Stop and Start Function

Renault CAPTUR 2024
426 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
STOP AND START FUNCTION
3
152 - Driving
This system enables a reduced fuel
consumption and lower greenhouse
gas emissions. The system is activated
automatically when the vehicle is
started. During driving, the system
stops the engine (standby) when the
vehicle comes to a stop or is moving at
a slow speed (depending on the
vehicle). The warning light is
displayed on the instrument panel.
Conditions of standby at low
speed
The vehicle has set off from where it
was parked;
For vehicles equipped with
automatic gearboxes:
the gearbox is in D, M or N position;
and
the brake pedal is pressed
(sufficiently hard);
If the warning light flashes, this
means that the brake pedal is not
sufficiently pressed;
and
the accelerator pedal is not pressed;
and
the speed is zero or, depending on
the vehicle, as soon as the speed is
lower than a threshold specific to the
vehicle.
The engine remains on standby if
position P is selected, or if position N
is selected with the handbrake
engaged and the brake pedal
released.
For vehicles equipped with manual
gearboxes:
the gearbox is in neutral;
and
the clutch pedal is released. If the
warning light flashes, this
means that the clutch pedal must be
released completely;
and
the vehicle speed is lower than a
threshold specific to the vehicle.
For all vehicles:
Warning light on the instrument
panel is lit when the engine is on
standby.
The vehicle equipment remains
operational while the engine is
stopped.
When the engine switches to standby,
the steering assistance may no longer
be operational.
In this case it becomes operational
again when the engine is no longer on
standby or the speed exceeds
approximately 1 mph (1 km/h)
(downhill, slope, etc.).
If the engine is put in
standby, the electronic
parking brake
(depending on the
vehicle) is not applied
automatically.
Keep your vehicle
stationary when the
engine is on standby
(shown by the warning
light on the instrument
panel).
Before leaving the
vehicle, the engine must
be stopped (not put in
standby) 🡺146.

Table of Contents

Related product manuals