REAR SEATS
2
Getting to know your vehicle - 59
Rear bench seat
Functions
To fold down the seatback
Ensure that the front seats are far
enough forward.
Before folding down a seatback:
– lower the headrests fully;
– place the seat belt in the belt guide
A
and buckle the seat belt. This
prevents the seat belt from locking
when the seatback is lifted up again.
Pull the handle
1
and lower the
seatback
B
.
Note: for safety reasons, the seatback
B
is equipped with a retaining system.
You may experience resistance when
handling.
To replace the seatback, proceed in
the reverse order to removal.
Raise the seatback again until it
reaches the locking joint of the
seatback.
Be careful not to jam the safety strap
between the backrest and the parcel
shelf.
Check the operation of the seat belt.
Before moving the
seatback, put seat belt in
belt guide
A
to avoid
damaging it.
When refitting the
seatback, make sure it
is correctly locked in
place.
If seat covers are fitted, make
sure these do not prevent the
seatback latch from locking in.
Make sure that the seat belts are
positioned correctly.
Reposition the headrests.
To move a seat forwards or backwards
Raise the lever
2
from the rear seats
to unlock the bench seat.
Move the seat forwards or back to the
required position.
Release the lever
2
and ensure that
the bench seat is properly locked.
For safety reasons, carry
out any adjustments
while the vehicle is
stationary.
To Next Page