1
2
3
NU747_1_G1-FRA.qxd 17/02/05 9:22 Page 1.18
BC85 - NU747-1
C:\Documentum\Checkout\NU747_1_T1-ENG.win 3/3/2005 11:53
-page24
1.18
FRONT HEADRESTS
To raise the headrest
Pull the headrest upwards to the
desired height.
To lower the headrest
Press button 1 and let the headrest
go down to the desired height.
To remove the headrest
Lift the headrest to its highest
position. Press button 2 and raise
the headrest to remove it.
Note: when the headrest is
removed, take care not to change the
positions of the rods 3.
To refit the headrest
If the rod setting has been altered,
withdraw the rods 3 as far as
possible by pulling upwards (check
their alignment and cleanliness)
and ensure that the notches are
facing forward.
Insert the headrest rods into the
holes (tilt the seatback backwards if
necessary).
Push the headrest downwards until
it clicks, check that it is properly
locked.
Press button 1 andpushthe
headrest down as far as it will go.
The headrest is a safety component, check that it is fitted and in the
correct position: the top of your head should be in line with the top
of the headrest.
To Next Page
Loading...
