parking distance control.............................
(current page)
operating faults ..........................................
(current page)
faults
operating faults ....................................
(current page)
2.135
ENG_UD73765_6
Aide au parking (BJA - Renault)
– select “BIP VOLUME” to adjust the
Park Assist volume using the 8 or 9
control.
Deactivating the parking
distance control manually
You must disable the function if:
– if towing, carrying or trailer equip-
ment that is unrecognised by the
system is present in front of the ul-
trasonic sensors;
– in the event of damage to the ultra-
sonic sensors.
Parking distance control
automatic deactivation
The system deactivates:
– when the vehicle speed is above
approximately 6 mph (10 km/h);
– depending on the model, when the
vehicle is stationary for more than
approximately 5 seconds and an ob-
stacle is detected (such as when in
a traffic jam, etc.);
– when the vehicle is in neutral on
manual gearboxes, or in position N
or P on automatic gearboxes;
PARKING DISTANCE CONTROL (5/7)
– when an operating fault is detected.
Note: if the vehicle is fitted with a
towbar recognised by the system, only
the rear Park Assist function is deacti-
vated.
Operating faults
When the system detects an operating
fault, a beep sounds for approximately
three seconds each time reverse gear
is selected and the message “Check
parking distance control” appears on
the instrument panel. Consult an ap-
proved dealer.
An impact to the under-
side of the vehicle while
manoeuvring (e.g. strik-
ing a post, raised kerb or
other street furniture) may result in
damage to the vehicle (e.g. defor-
mation of an axle).
To avoid any risk of accident, have
your vehicle checked by an ap-
proved dealer.
Vehicles not fitted with a multimedia
screen
– With the vehicle stopped, press the 7
switch as many times as required to
reach the “Vehicle” tab;
– press the 8 or 9 control repeatedly
to reach the “Settings” menu. Press
the switch 10 OK;
– press the 8 or 9 control repeatedly
to reach the “PARKING ASSIST”
menu. Press the switch 10 OK;
7
8
9
10
To Next Page
Loading...
