5.5
The tool kit is located in the luggage
compartment.
The composition of the tool kit varies
according to the vehicle.
Wheelbrace 6
Jack 7
When replacing the jack, fold it cor-
rectly and position the wheelbrace cor-
rectly before replacing it in its position.
Hubcap tool 8
This tool is used to remove the wheel
trims.
Wheel bolt guide 9
To finish loosening or starting to tighten
the wheel bolts.
Towing hitch 10
Refer to the information on “Towing” in
Section 5.
Headlight spanner 11
(one or two hubcap tools provided, de-
pending on the vehicle)
Used to unscrew the headlights.
7
6
8
10
Wheel trim
Remove using the hubcap tool 8 by
connecting the hook in the recess pro-
vided next to the valve 12 (to attach the
metal clip).
To refit the hubcap, align it with
valve 12. Push the retaining hooks in
fully, starting with side B near the valve,
followed by C and D, finishing at E op-
posite the valve.
Note: if you are using anti-theft bolts,
refer to the information on “Changing a
wheel”.
12
B
C
D
E
9
11
TOOL KIT (2/2)/ WHEEL TRIM - WHEEL
The jack is designed for
wheel changing purposes
only. Under no circum-
stances should it be used
for carrying out repairs underneath
the vehicle or to gain access to the
underside of the vehicle.
To Next Page
Loading...
