1.71
Finishing by pressing and holding
button 5 to confirm the time set.
When the minutes flash, repeatedly
press or press and hold button 4 to set
them.
The fixed display on the hours and min-
utes for two seconds confirms the hour
and minute setting.
Press button 4 or 5 to exit time setting
mode.
Display C
(vehicle with setting buttons 4 and 5)
With the ignition on, press button 4 or 5
to enter time setting mode: display 3
appears.
Wait for the hours and minutes to flash.
Press and hold button 5 to select the
hours.
When the hours flash, repeatedly press
or press and hold button 4 to set them.
C
3
CLOCK AND EXTERIOR TEMPERATURE (2/2)
If the power supply is cut (battery
disconnected, supply wire cut, etc.),
the clock must be reset.
We recommend that you do not
adjust these settings while driving.
4
5
4
5
C
To Next Page
Loading...
