Renault SENIC - Front Head Restraints

1
1
B
C
A
QXBIUDB*T[G 3DJH 
MEGANE SCENIC MONOSPACE NU 641-1
C:\Documentum\Checkout\nu641-1_eng_T1.WIN 21/2/2001 11:31
-page17
1.11
FRONT HEAD RESTRAINTS
To raise or lower the head
restraint:
Pull the head restraint towards you
A and slide it up at the same time B.
To remove the head restraint:
Raise the head restraint, lift tab 1
andthenliftouttheheadrestraint
until it is released from the fitting.
To adjust the tilt angle:
On certain vehicles it is possible to
adjust the tilt angle of the head
restraint. To do this, move the front
section C of the head restraint
forwards or backwards until it feels
comfortable.
To refit the head restraint:
Insert the rods into the sleeves, with
the notches facing towards the
front.
Lower the head restraint until it
latches in position.
The head restraint is
important for safety.
Ensure that it is in place
and in the correct
position. The distance between
your head and the head restraint
should be as small as possible.
The top of the head should be in
line with the top of the head
restraint.