Renault SENIC - Page 174

1
2
3
QXBIUDB*T[G3DJH
MEGANE SCENIC MONOSPACE NU 641-1
C:\Documentum\Checkout\nu641-1_eng_T5.WIN 21/2/2001 12:02
-page24
5.24
FITTING A RADIO
Fitting a radio
Remove the radio fuses (refer to the
information on “Fuses” in section 5).
Unclip cover 1. Connections: aerial,
+ and – feed, left and right speaker
wires are at the rear. (These are
connected to locations in the
dashboard, the doors and to rear
locations.)
Tweeter speakers
Unclip grille 2 using a tool such as a
screwdriver to gain access to the
speaker wires.
Door speakers
Unclip grille 3 at the points
indicated by the arrows using a tool
such as a flat screwdriver.
Remove the four screws and then
take off the protective card to reach
the speaker wires.
• In all cases, follow the manufacturer’s fitting instructions carefully.
• The specifications of the supports and wires (available as a Renault parts
accessory) vary depending on equipment level of your vehicle and the type
of radio.
To find out their reference, consult your Renault Dealer.