lighting:
exterior ............................................(up to the end of the DU)
instrument panel ....................................................(current page)
lights:
side lights .........................................................(current page)
lights:
dipped beam headlights ...................................(current page)
hazard warning lights signal ..................................(current page)
signals and lights ..................................(up to the end of the DU)
lighting:
instrument panel ..............................................(current page)
daytime running lights............................................(current page)
1.82
ENG_UD53725_4
Éclairages et signalisations extérieurs (X10 - Renault)
Exterior lighting and signals
EXTEri Or ligh TiNg AND Sig NAl S (1/3)
Before driving at night, check that the electrical equipment is operating
correctly and adjust the headlight beams (if your vehicle is not carrying
its normal load). As a general precaution, check that the lights are not ob-
scured (by dirt, mud, snow or objects being transported).
31
k
Dipped beam
headlights
manual operation
Turn the ring 2 until the symbol is oppo-
site mark 3. This indicator light on the
instrument panel comes on.
Automatic operation
(depending on vehicle)
Turn ring 2 until the AUTO symbol is op-
posite mark 3: with the engine running,
the dipped beam headlights switch on
or off automatically depending on the
brightness of the light outside, without
any action on stalk 1.
2
If driving on the left in a left-hand
drive vehicle (or vice versa), drivers
must have the lights adjusted by an
authorised dealer for the duration of
the trip.
1
u
Side lights
Turn the ring 2 until the symbol
is opposite mark 3. This indicator light
on the instrument panel comes on.
Daytime running lights
The daytime running lights come on
automatically with no action on stalk 1
when the engine is started, and they go
off once the engine is switched off.
To Next Page
Loading...
