starting ..................................................(up to the end of the DU)
starting the engine ................................(up to the end of the DU)
driving ...................................................(up to the end of the DU)
starting the engine ................................(up to the end of the DU)
2.2
ENG_UD41187_3
Démarrage (X10 - Renault)
Starting, stopping the engine
STAr TiNg, STOPPiNg ThE ENgi NE (1/3)
The vehicle can only be started if
the charging cord is unplugged from
the vehicle.
The vehicle can only be started if the
selection lever is at P. Please see
the information on “Gear control” in
Section 2.
remote control rENAUl T
card
When you get into the vehicle, insert the
RENAULT card fully into card reader 2.
To start
– position the gear lever to the posi-
tion P only;
– press button 1. The message
rEADY comes on, on the instrument
panel, along with a beep.
The message disappears when the
vehicle speed is above approximately
3.1 mph (5 km/h).
hands-free rENAUl T card
The RENAULT card must be inserted
in card reader 2 or in detection zone 3.
To start
– position the gear lever to the position
P only ;
– depress the brake pedal;
– press button 1. The message
rEADY comes on, on the instrument
panel, along with a beep.
The message disappears when the
vehicle speed is above approximately
3.1 mph (5 km/h).
3
1
2