Why is my Renfert Basic classic Dental equipment unit blasting continuously?
If your Renfert Dental equipment unit is blasting continuously, it could be due to the foot switch being connected incorrectly. Inspect and correct the foot switch connection. Alternatively, the valve in the foot switch may be defective, in which case you should replace the foot switch.
What to do if Renfert Basic classic has only air, but no or very little abrasive?
If your Renfert Dental equipment is dispensing only air with little to no abrasive, the metering nozzle at the tank might be blocked. Try unscrewing the tank cover. Another possibility is a blocked mixing chamber filter combination; try sealing the top of the riser pipe (blue hose) with a piece of insulation or Sello tape. Finally, the abrasive itself may be impure or moist, in which case you should replace it.
How to fix Renfert Basic classic lamp that does not go on?
If the lamp on your Renfert Dental equipment does not turn on, first ensure the power cord is properly plugged into the wall outlet. If it's plugged in, the fluorescent tube may be defective and need replacement. Faulty electronics could also be the cause, requiring service to replace the electronics. Another potential issue is that the fluorescent tube is not properly seated in the socket.
What to do if Renfert Basic classic Dental equipment has no air and no abrasive?
If your Renfert Dental equipment is dispensing neither air nor abrasive, the blasting nozzle at the hand-piece might be blocked. Unscrew the nozzle from the hand-piece and blow it out. Also, check the foot switch connecting lines for any kinks and correct them if necessary. For 2-tanks versions, ensure the switch is not set to an intermediate position; turn the switch until you feel it click into place.
General| Category | Dental equipment |
|---|---|
| Manufacturer | Renfert |
| Model | Basic classic |
| Abrasive media | Aluminum oxide, Glass beads |
| Operating pressure | 4 - 6 bar |
| Connection | 6 mm air hose |
| Voltage | 230 V |
| Weight | 2.5 kg |
| Type | Sandblasting unit |
To Next Page
