Why is there excessive noise while the trimmer disc is running on my Renfert Laboratory Equipment?
Excessive noise during trimmer disc operation in your Renfert Laboratory Equipment may indicate that the disc isn't adequately tightened. Try hand-tightening the disc. If the issue persists, reinstall the disc.
How to fix a wobbling trimmer disc on Renfert Laboratory Equipment?
A wobbling trimmer disc on your Renfert Laboratory Equipment could be due to a couple of reasons. First, check if the disc is lying flush on the flange. If not, reinstall the disc, ensuring it's correctly mounted on the lock pin. Another possibility is that the disc isn't tightened enough. Hand-tighten the disc to secure it properly.
What to do if my Renfert Laboratory Equipment device fails to start?
If your Renfert Laboratory Equipment device isn't starting, several factors could be at play. First, ensure that the mains power supply is properly connected. Next, check the mains fuse to see if it's faulty. Also, make sure that the front cover is completely closed. Finally, the motor might be overheated; allow it to cool down before restarting it using the main power switch.
What to do if the trimmer table is wobbling on my Renfert Laboratory Equipment?
If the trimmer table on your Renfert Laboratory Equipment is wobbling, it's likely that the trimmer table is incorrectly installed. Reinstall the table according to the directions.
General| Brand | Renfert |
|---|---|
| Model | MT plus |
| Category | Dental equipment |
| Language | English |
To Next Page
