Renfert MT plus - 10 Troubleshooting Guide; Technical Specifications

en
9 Technical Specications
Mains voltage:
220 - 230 V, 50 / 60 Hz
230 - 240 V, 50 Hz
120 V, 60 Hz
100 V, 50 / 60 Hz
Power consumption:
220 - 230 V: 1300 W (1,743 hp)
230 - 240 V: 1300 W (1,743 hp)
120 V: 1500 W (2,012 hp)
100 V: 1200 W (1,609 hp)
Water consumption, max�: 9 l/min� [0�32 cfm]
Necessary water pressure:
- min�:
- max�:
1 bar [14�5 psi]
5 bar [72�5 psi]
Speed:
50 Hz: 2850 1/min
60 Hz: 3400 1/min
Connection piece diameters for external extraction: 36 mm [1�42 inch]
Dimensions (W x H x D):
300 x 320 x 410 mm
[11�8 x 12�6 x 16�2 inch]
Ø Trimmer disc dimensions: 234 mm [9�2 inch]
Weight: 13,5 kg [30 lbs]
Sound pressure level accord� to DIN 45635-01-KL3,
measured under full load:
- Lp(A):
- K:
74 dB(A)
4 dB
10 Troubleshooting Guide
Fault Possible cause Corrective action
Device fails
to start.
• Power supply not established�
• Mains fuse faulty�
• Front cover not properly closed�
• Motor overheated�
• Check the mains power supply�
• Check the mains fuse�
• Close the front cover (Fig� 11)�
• Allow the motor to cool down, then restart at
the main power switch�
Trimmer disc
wobbles.
• Discisnotlyingushonthe
ange.
• Discnottightenedsufciently.
• Reinstall the disc according to the directions�
Pay attention that the disc is mounted exactly
on the lock pin (Fig� 30)�
• Remove all deposits from the back of the disc
andfromthestoppingfaceoftheange.
• Hand-tighten the disc (Fig� 29)�
Excessive
noise while
the trimmer
disc is run-
ning.
• Disc not adequately tightened� • Hand-tighten the disc (Fig� 29), or reinstall, as
required (Sec� 8�1)�
Trimmer table
wobbling.
• Trimmer table incorrectly installed� • Reinstall the table according to the directions
(Fig� 40)�
- 8 -