Renishaw TS27R User Manual

1Contents
Safety ..................................................................2
Safety ............................................................2
TS27R probe system .........................................4
Introduction ...................................................5
Operation ............................................................6
Achievable set-up tolerances ........................6
Recommended rotating tool feedrates ..........6
First touch – machine spindle rev/min ...........6
First touch – machine feedrate ...................... 6
Second touch – machine feedrate.................6
Software routines ..........................................6
Specication ......................................................7
Dimensions ........................................................9
Installation ........................................................10
Mounting the probe on the
machine table ..............................................10
Spirol
®
pins ..................................................10
Cable ...........................................................10
Interfaces ....................................................11
Recommended connection diagram for
TS27R with HSI-C interface ............................12
Recommended connection diagram for
TS27R with HSI interface ................................13
Recommended connection diagram for
TS27R with MI 8-4 interface ............................14
Fitting the stylus and captive link .................. 16
Break stem .......................................................17
Stylus level setting ..........................................18
Square stylus alignment .................................19
Service and maintenance ...............................20
Service ........................................................20
Maintenance ................................................ 20
Diaphragm maintenance .................................21
Parts list ...........................................................22
General information ........................................25
Disclaimer ...................................................25
Trade marks ................................................25
Warranty ......................................................25
China RoHS ................................................25
Changes to equipment ................................26
CNC machines ............................................26
Care of the probe ........................................26
EU declaration of conformity .......................26
WEEE directive ...........................................27
REACH regulation .......................................27
FCC Information to user (USA only) ...........27

Renishaw TS27R Specifications

General

Type	Tool setting probe
Hard-wired	Yes
Repeatability	1.0 µm (0.00004 in) 2σ
Stylus Tip Diameter	2 mm
Operating Voltage	5 V DC
Operating Temperature Range	5°C to 50°C
Storage Temperature Range	–10°C to 70°C