EasyManuals Logo

Renogy Wanderer 30A User Manual

Renogy Wanderer 30A
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
3
Battery Safety
Do NOT let the positive (+) and negative (-) terminals of the battery touch each
other.
Use only sealed lead-acid, flooded, or gel batteries which must be deep cycle.
Explosive battery gases may be present while charging. Be certain there is enough
ventilation to release the gases.
Be careful when working with large lead acid batteries. Wear eye protection and
have fresh water available in case there is contact with the battery acid.
Over-charging and excessive gas precipitation may damage the battery plates and
activate material shedding on them. Too high of an equalizing charge or too long
of one may cause damage. Please carefully review the specific requirements of
the battery used in the system.
WARNING: Connect battery terminals to the charge controller BEFORE connecting
the solar panel(s) to the charge controller. NEVER connect solar panels to charge
controller until the battery is connected.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Renogy Wanderer 30A and is the answer not in the manual?

Renogy Wanderer 30A Specifications

General IconGeneral
BrandRenogy
ModelWanderer 30A
CategoryInverter
LanguageEnglish

Related product manuals