97
en
Healthbox
®
3.0
Introduction
This manual consists of 2 parts:
• Part 1 - User: guide to the operation of the device
• Part 2 - Installer: guide for performing a correct installation
General safety regulations
Always follow the safety regulations, warnings, comments and instructions from this
manual. If these safety regulations, warnings, comments and instructions are not followed, it could
lead to damage to the Healthbox 3.0 or to personal injury, for which RENSON
®
NV cannot be
held responsible.
• Installation of the Healthbox 3.0 must be performed in accordance with the general and locally
applicable regulations regarding construction, safety and installation requirements of the
municipal/urban and/or other bodies.
• Only a qualified electrician (or supported by a qualified installer) should install, connect,
commission and maintain Healthbox 3.0 differently than as described in this manual.
• All wiring must be done by a qualified person.
• Please ensure that the electrical power supply for Healthbox 3.0 corresponds to the
requirements in this guide.
• If the power cord is damaged, it must be replaced by the manufacturer, its service
representative or similar qualified persons to avoid danger.
• Healthbox 3.0 is constructed so that in normal use, and without deliberate action, it is not
possible to come into contact with moving or live parts.
• The device must be mounted in a touch-proof manner. This means that, under normal operating
conditions, no one can come into contact with moving or live parts of the fan unit without a
deliberate action such as:
– Disassembling the cover plate (and motor plate).
– Disconnecting an air duct and/or protective cover on the suction points during normal use.
To Next Page
Loading...
Need help?
General
