EN
18
1 • 1. Professional product
The Healthbox
®
II is a product for professional installers
The Healthbox
®
II can only be switched on by RENSON
®
installers that sell the system and provide
customers with the necessary support!
The installer must make sure that the ventilation ducts are properly connected to the unit and that the
dipswitches are configured correctly. He must also calculate the total power consumption and
calibrate the unit.
The calibration process is finished when All LEDs on the control valves turn green.
The system will then operate in C-mode for about 30 minutes.
Only then the professional installer can complete & fill in the protocol for operation.
ATTENTION:
The private customer cannot fill in the protocol himself. RENSON
®
Ventilation NV cannot be held
accountable when the Healthbox
®
II is sold separately without proper support and without a
proper calibration. All warranty expires when the ventilation system is installed badly or when the
ventilation ducts are not connected and installed properly .
Remark regarding installation:
See instructions in the packaging when you wish to suspend the Healthbox
®
from the ceiling by the
included cord.
To Next Page
Loading...
Need help?
General
