EN 25
4 • Calibration
• Starting the calibration:
- Healthbox
®
II is plugged in
- LEDs on the control valves blink orange and green
- Central print registers which type of control valves are
connected to the Healthbox
®
II
- Only the green LEDs will light up after a successful
automatic communication
- The status LED on the main print will continually blink red
Remark
When a RENSON
®
cooker hood is connected to one of the control valves, make sure
the cooker hood is activated before starting the calibration procedure.
(open the slider in case of a telescopic cooker hood)
• When calibrating it is important to:
1. Open all window vents
2. Close all interior doors
3. Perform the calibration procedure on a wind still day. Max 2 beaufort
(wind can felt on your face, leaves rustle)
To Next Page
Loading...
Need help?
General
