ResMed S9 Series Information Guide

13
English

H5I WARNINGS
• The H5i is designed only for use with specific ResMed devices. Do not use the H5i with any
other bilevel device.
• Do not operate the H5i if it is not working properly or if any part of the bilevel device or H5i has
been dropped or damaged.
• The H5i should only be used with tubing or accessories recommended by ResMed. Connection
of other delivery tubes or accessories could result in injury, or damage to the device.
• Water must be prevented from entering your bilevel device.
• Do not overfill the water tub as water may enter the device and air tubing.
• Do not use any additives (eg, scented oils and perfumes). They may reduce the humidification
output of the H5i and/or cause deterioration of the water chamber materials.
• Take care when handling your H5i as the water/water tub may be hot. Allow 10 minutes for the
heater plate and any excess water to cool.
• The H5i docking station should only be connected or disconnected when the water tub is
empty.
• Make sure that the water tub is empty before transporting the H5i.
• Do not operate the H5i on an aircraft as water may enter the bilevel device and air tubing during
turbulence.
• Always place the H5i on a level surface below the level of the user to prevent the mask and
tubing from filling with water.
• The H5i should be used with caution for users who are unable to remove the mask for
themselves.
• If liquids are inadvertently spilled into or on the H5i docking station, unplug the device from the
power outlet. Disconnect the docking station from the bilevel device and allow the docking
station to drain and dry before re-using.
AIR TUBING WARNINGS
• Do not use the air tubing if there are any visible signs of damage.
• Do not wash the air tubing in a washing machine or dishwasher.
• The ClimateLine is designed only for use with the H5i.
• ClimateLine is not compatible with supplemental oxygen.
• When using the ClimateLine or SlimLine above 20 cm H
2
O the device optimum performance
may not be reached.

ResMed S9 Series Specifications

General

Data Storage	SD card
Device Type	CPAP Machine
Pressure Range	4 to 20 cm H2O
Sound Level	24 dB
Power Supply	100-240V AC, 50/60Hz
Therapy Modes	CPAP, VPAP ST, VPAP Auto
Altitude Adjustment	Yes
Operating Temperature	+41°F to +95°F (+5°C to +35°C)
Operating Humidity	10% to 95% non-condensing
AC Voltage	100-240V AC
Humidifier	optional
Ramp	Yes