ReSound RT561-DRWC - Replacing Mic Filter in M&RIE Rec Tube

Doc 0371130 rev. F
Page 17 of 22
Not subject to issue control when printed
Replacing Mic Filter in M&RIE Rec Tube
Locate the mic lter at the back of the rec tube. Use the lter removal end of the mic lter pin to remove the defective lter. Make sure the pin is pushed
all the way in to get the best grip on the defective lter (see red circle)
Pull back the pin with the defective lter. In the other end of the lter pin, the new lter is attached. Push it into the hole/mic sound inlet. Make sure the lter
is correct in place. Turn the pin clockwise until the new lter is released
Filter
No lter
New
lter
Pull back the pin. Check that the lter is correct in place
Filter
removal