How to fix air leaking from around my Resvent Medical Equipment mask?
If air is leaking from around your mask, it might not be fitted correctly. Ensure your mask is properly fitted. Refer to your mask user guide for fitting instructions or use the Mask Fit function to check the fit and seal.
What to do if my Resvent iBreeze 20A Pro device doesn't turn on?
If your device isn't turning on, check the outlet to ensure it has power and that the device is properly plugged in. Verify the AC power cord is correctly connected to the power supply and the power supply cord is securely connected to the device’s power inlet. If the problem persists, contact your home care provider, returning both the device and power supply for assessment.
Why is my mouth so dry using Resvent iBreeze 20A Pro Medical Equipment?
If your mouth is very dry and uncomfortable while using the device, it could be due to air escaping through your mouth. Try increasing the Humidity Level. Alternatively, consider using a chin strap to keep your mouth closed or switch to a full face mask.
How to stop a dry nose with Resvent iBreeze 20A Pro Medical Equipment?
If you're experiencing a dry or blocked nose, the humidity level might be set too low. Adjust the Humidity Level to a more comfortable setting.
What to do if I get water droplets with Resvent iBreeze 20A Pro?
If you're getting droplets of water on your nose, in the mask, and air tubing, the humidity level might be set too high. Adjust the Humidity Level to reduce condensation.
Why is the air pressure too low in my Resvent iBreeze 20A Pro Medical Equipment mask?
If the air pressure in your mask seems too low, the Ramp function might be in progress. Either wait for the air pressure to build up or turn the Ramp Time off.
Why is my Resvent iBreeze 20A Pro water tank leaking?
If your water tank is leaking, it may not be assembled correctly, or it could be damaged or cracked. Check for any damage and reassemble the water tank correctly. If the leak persists, contact your care provider for a replacement.
Why does my Resvent Medical Equipment keep blowing air after stopping therapy?
The device blows a small amount of air after therapy has stopped to prevent condensation in the air tubing. It will stop automatically after a few minutes.
What to do if Resvent iBreeze 20A Pro display is erratic?
If the device's display is erratic (crashes, blank or blue screen), it may be due to the device being dropped or mishandled. Unplug the device, then reapply power. If the problem continues, contact your home care provider.
What to do for a non-responsive key on Resvent iBreeze 20A Pro Medical Equipment?
If you are experiencing a key exception (non-responsive or insensitive), it may be due to program crashes or key misalignment. Unplug the device, then reapply power. If the problem continues, contact your home care provider.
Instructions on how to enter and exit the device's clinical configuration mode.
Describes the main screen displayed after entering clinical mode.
Details the interface shown during active therapy sessions.
Explains the CPAP therapy mode and its parameters.
Details the CPAP-V mode for patient titration.
Describes the APAP mode with automatic pressure adjustment.
Categorizes the different types of alerts the device can generate.
Provides a detailed table of alerts, their causes, and actions.
General| Pressure Range | 4-20 cm H2O |
|---|---|
| Humidifier | Integrated heated humidifier |
| Power Supply | 100-240V AC, 50/60Hz |
| Modes | CPAP, Auto CPAP |
| Data Storage | SD Card |
| Battery Backup | Optional external battery |
| Device Type | CPAP |
| Display | LCD |
| Ramp Time | 0-45 minutes |
To Next Page
