To Next Page
A
Angela DavisSep 8, 2025
What to do if Resvent Medical Equipment displays low PEEP?
- DdhamiltonSep 8, 2025
If the Resvent Medical Equipment displays low PEEP, check the patient tubing for leakage and perform a system check to test for leakage.
What to do if Resvent Medical Equipment displays low PEEP?
If the Resvent Medical Equipment displays low PEEP, check the patient tubing for leakage and perform a system check to test for leakage.
What to do if Resvent Medical Equipment shows high pressure?
If the Resvent Medical Equipment displays a high pressure warning, check the patient, adjust the pressure alarm limit, and inspect the breathing circuit and flow sensor tubes for any kinks or occlusions. If the issue persists and the ventilator enters the ambient state, provide alternative ventilation.
What to do if Resvent Medical Equipment shows low pressure?
If the Resvent Medical Equipment indicates low pressure, check the patient, verify the ventilation parameter setup and alarm limits. Also, check the patient tubing for leaks or disconnections.
What to do if Resvent Medical Equipment displays pressure limited in sigh cycle?
If the Resvent Medical Equipment displays pressure limited in sigh cycle, check parameter settings, including pressure high alarm limit setting.
What to do if Resvent iHope RS300 says battery missing?
If the Resvent Medical Equipment indicates that the battery is missing, insert a battery.
What to do if Resvent iHope RS300 displays battery1 recharge failed, temperature low?
If the Resvent Medical Equipment indicates that Battery1 recharge failed due to low temperature, connect it to the external power supply and wait for the machine to return to normal temperature.
What to do if Resvent iHope RS300 displays patient circuit occluded?
If the Resvent Medical Equipment indicates the patient circuit is occluded, check and clean the breathing circuit and the expiration valve.
What to do if Resvent Medical Equipment displays high PEEP?
If the Resvent Medical Equipment displays high PEEP, check the patient and confirm that the ventilator and alarm settings are appropriate.
What to do if Resvent Medical Equipment prompts to calibrate pressure sensor?
If the Resvent Medical Equipment prompts you to calibrate the pressure sensor, perform a pressure sensor calibration.
What to do if Resvent iHope RS300 shows high frequency?
If the Resvent Medical Equipment displays a high frequency, check the patient for adequate ventilation and adjust the high frequency alarm limit.
General safety guidelines, warnings, cautions, and notes.
Procedure for connecting the patient breathing circuit.
How to connect the ventilator to oxygen sources.
Steps for connecting the ventilator to AC power.
Overview of the ventilator's main screen layout and elements.
Configures fundamental ventilation parameters and system options.
Steps to power on the ventilator and initial checks.
Performing pre-use system checks for proper operation.
Setting up patient information for ventilation.
Choosing between invasive and non-invasive ventilation.
Selecting and configuring various ventilation modes.
Classifies alarms by type and severity level.
Describes visual and audible cues for alarms.
Adjusting volume, limits, and pausing audible alarms.
Procedures for addressing and resolving active alarms.
Performing alarm tests and disabling alarms.
General guidelines and warnings for maintenance procedures.
Regular checks and replacements to ensure optimal performance.
Procedures for battery care, charging, and replacement.
Procedures for ensuring electrical safety and compliance.
Outlines recommended cleaning and disinfection procedures.
Instructions for disassembling key ventilator components for cleaning.
General| Pressure Range | 4-30 cmH2O |
|---|---|
| IPAP | 4-30 cmH2O |
| Humidification | Integrated heated humidifier |
| Data Storage | SD card |
| Operating Voltage | 100-240 V AC, 50/60 Hz |
| Type | Bi-Level |
| Therapy Mode | CPAP, S, T, S/T |
| Inspiratory Time | 0.5-3.0 seconds |
