How to fix air leaking from around my Resvent iBreeze 20A Medical Equipment mask?
If air is leaking from around your mask, it might not be fitted correctly. Ensure your mask is properly fitted. Refer to your mask user guide for fitting instructions or use the Mask Fit function to check the fit and seal.
What to do if my Resvent iBreeze 20A Medical Equipment device doesn't turn on?
If your device isn't turning on, check the outlet to ensure it has power and that the device is properly plugged in. Verify the AC power cord is correctly connected to the power supply and the power supply cord is securely connected to the device’s power inlet. If the problem persists, contact your home care provider, returning both the device and power supply for assessment.
Why is my mouth so dry using Resvent iBreeze 20A Medical Equipment?
If your mouth is very dry and uncomfortable while using the device, it could be due to air escaping through your mouth. Try increasing the Humidity Level. Alternatively, consider using a chin strap to keep your mouth closed or switch to a full face mask.
How to stop a dry nose with Resvent iBreeze 20A Medical Equipment?
If you're experiencing a dry or blocked nose, the humidity level might be set too low. Adjust the Humidity Level to a more comfortable setting.
What to do if I get water droplets with Resvent iBreeze 20A Medical Equipment?
If you're getting droplets of water on your nose, in the mask, and air tubing, the humidity level might be set too high. Adjust the Humidity Level to reduce condensation.
Why is the air pressure too low in my Resvent Medical Equipment mask?
If the air pressure in your mask seems too low, the Ramp function might be in progress. Either wait for the air pressure to build up or turn the Ramp Time off.
Why is my Resvent Medical Equipment water tank leaking?
If your water tank is leaking, it may not be assembled correctly, or it could be damaged or cracked. Check for any damage and reassemble the water tank correctly. If the leak persists, contact your care provider for a replacement.
Why does my Resvent Medical Equipment keep blowing air after stopping therapy?
The device blows a small amount of air after therapy has stopped to prevent condensation in the air tubing. It will stop automatically after a few minutes.
What to do if Resvent Medical Equipment display is erratic?
If the device's display is erratic (crashes, blank or blue screen), it may be due to the device being dropped or mishandled. Unplug the device, then reapply power. If the problem continues, contact your home care provider.
What to do for a non-responsive key on Resvent iBreeze 20A?
If you are experiencing a key exception (non-responsive or insensitive), it may be due to program crashes or key misalignment. Unplug the device, then reapply power. If the problem continues, contact your home care provider.
Guides on how to access, view, and set therapy and device configuration parameters.
Explains the CPAP mode, delivering constant pressure throughout therapy.
Describes CPAP-V mode, a titration mode combining CPAP and APAP.
Details APAP mode, where pressure adapts automatically based on patient status.
Specifies APAPW mode for female patients with enhanced sensitivity.
Explains how the device detects and responds to sleep events like apnea and hypopnea.
Details the rules governing automatic pressure adjustments based on detected sleep events.
General| Pressure Range | 4-20 cmH2O |
|---|---|
| Humidification | Integrated heated humidifier |
| Data Storage | SD card |
| Display | LCD screen |
| Power Supply | 100-240 V AC, 50/60 Hz |
| Ramp Time | 0 to 45 minutes |
| Sound Level | Less than 30 dBA |
To Next Page
