Retevis RA85 - Page 7

1 Step 2.5KHz In frequency mode, press ▲ / ▼ key to change the step value
5.0KHz of frequency, the value range is 2.5~50KHz
6.25KHz
10.00KHz
12.50KHz
20.0KHz
25.0KHz
50.0KHz
2 Tx Power High High power transmission
Middle Medium power transmission
Low Low power transmission
3 Power save OFF Turn off power saving mode
ON Turn on power saving mode
4 Vox Level OFF Turn off VOX
1,2,… 10 The level intensity of voice activation, the value range is 1~10.
5 Backlight Bright Backlight is always on
OFF Backlight off
5Sec,10Sec,… 60Sec Automatic backlight delay time, the range is 5~60 seconds
6 Menu Exit Time 5Sec,10Sec,… 60Sec Automatic backlight delay time, the value range is 5~60 seconds
7 Dual Standby OFF Dual Standby off
ON Dual Standby on
8 Beep Prompt OFF Beep Prompt off
ON Beep Prompt on
9 VOICE OFF Prompt voice off
ON Prompt voice on
OFF Press and hold the PTT button to keep transmitting
10 Tx over time
15,30,…600 Value range 15~600, step value 15
11
12
13
14
15
Rx DCS
Rx CTCSS
Tx DCS
Tx CTCSS
DTMFST
16
17
TONE
S-CODE
OFF
OFF
OFF
OFF
OFF
DCS off
DCS Standard sequence
CTCSS off
D023N,…,D754I
67.0HZ,…,254.1HZ
D023N,…,D754I
67.0HZ,…,254.1HZ
1,2，…,15
1000hz,1450hz,
1750hz,2100hz
DT-ST
ANI-ST
DT+ANI
DCS Standard sequence
Repeater activation audio
When needed, send out this group of information codes
(information codes can only be written by frequency writing
software)
DCS off
CTCSS off
CTCSS Standard sequence, At the same time, you can
directly type standard or non-standard CTCSS by keyboard
CTCSS Standard sequence, At the same time, you can
directly type standard or non-standard CTCSS by keyboard
5