Retevis RB627B - Page 13

10
10.
2> Press [MENU] key again to enter the BCLO menu;
3> Press [+UP]/ [-DOWN] key to select the switch and select the range ON/OFF;
4> Press [MENU] key to confirm;
5> Press [PTT] or [MONI] key to exit the menu mode.
6.2.11 Call Tone Select (RING)- MENU 11
This setting will allow you to transmit a unique Call Tone alert to identify your radio when you
transmit messages. You can select from one of 10 different Call Tone signals. To Set Call Tone:
1> Press [MENU] key to enter the main menu, press [+UP]/ [-DOWN] key to enter the MENU 11.
2> Press [MENU] key again to enter the RING menu;
3> Press the [+UP]/ [-DOWN] key to select a different Call Tone. An example of each call tone will
sound for 1.5 seconds.
Note: OFF-turn off the call reminder tone; during the selection of 1-10, you can listen to the call
tone. Before you initiate a voice intercom, you can press the CALL key to remind the call.
4> Press [MENU] again to confirm;
5> Press [PTT] or [MONI] key to exit the menu and return to normal operation mode.
6.2.12 VOICE Selection (VOICE) - MENU 12
Your radio has voice prompt function for channel and function operation, you can choose to
switch voice function or prompt language type. The setting steps are as follows:
1> Press [MENU] key to enter the main menu, and press [+UP]/ [-DOWN] key to enter the MENU
12.
2> Press [MENU] key again to enter the VOICE menu;
3> Press [+UP]/ [-DOWN] key to OFF or Chinese and English selection, the selection range is
OFF/CHI/ENG
Note: OFF-turn off the voice prompts function; CHI-prompt voice is Chinese; ENG-prompt voice
is English.
After turning off the voice prompt function, there will be a beep prompt when you select a channel
or menu setting.
4> Press [MENU] key to confirm;
5> Press [PTT] or [MONI] key to exit the menu mode.
6.2.13 Restore factory settings (RESET)-MENU 13
Your radio has a reset function. To reset the radio, proceed as follows:
1>Press [MENU] key to enter the main menu, and press [+UP]/ [-DOWN] key to enter the MENU
13, the screen displays
RESET.
2> Press [MENU] key to confirm, and the radio resets the parameters.